Body'
Body' Guangzhou Instrument Maintenance
Body' engineer talks about the use and maintenance of water bath here
Body' Body' First, turn on the power of the water bath and select the instrument to detect the temperature. When using it, you must The correct temperature accuracy can only be achieved after heating and constant temperature for more than two times, and it can only be achieved after all caps and rings are sealed. You also need to add an appropriate amount of clean tap water to the pot first. You can also add hot water according to the required temperature to shorten the heating time.
Body' Body' When using the digital display head, the maximum digit of the counter is ten digits, and the operation symbol is increment or subtraction. The traffic light changes with the change of the temperature in the pot. The green light indicates that the heater is working, and the red light indicates the constant temperature.
Body' Body' When using an electronic thermostat, adjust the temperature knob clockwise to the required temperature. At this time, the green indicator light will light up in the heating status. When heated to the required temperature, the red indicator light lights up to the constant temperature state.
Body' Body' The amount of water in the water bath should not be less than half, and the heating tube should not be exposed to the water to avoid burning. However, do not add too much water to prevent the water from overflowing out of the pot when boiling. When the work is completed, set the temperature control knob and increase/decrease to the minimum value and cut off the power.
体' 体' For more knowledge on instrument maintenance and measurement calibration, please continue to pay attention to this website and share it with everyone every day
Service hotline Ms. Chen
Consultation (Foshan Measurement Calibration Center)
/>body'
News